Push one short tubing onto the end of the nipple of each Flow Plug,
push the other ends onto the two straight ends of the 3-way Barbed
Connector, push the end of the 5’ tubing onto the top end of the 3-way
Barbed Connector, slide the Tubing Clamp onto the 5’ tubing, pull
enough tubing through one of the holes in the Lid so that the end can
reach the bottom of the bottle.
Within an hour of when you intend to hook up the Christmas Tree I-V,
locate a spot about 10" from the bottom of the trunk and drill one hole
as shown using a 1/2" drill bit. Move around the tree and drill another
hole so that it crosses the first hole.
Drill in more than halfway but NOT COMPLETELY THROUGH.
Fill the bottle with plain tap water (add 1tablespoon of liquid bleach to
the initial fill). Put the Christmas Tree I-V™ unit Lid on the bottle making
sure that the end of the tubing reaches the bottom.
Let the Flow Plugs dangle in the sink & while holding your finger over
the vent hole in the Lid, gently squeeze the bottle until water flows out
of the Flow Plugs.
A siphon is created and water will continue to come out of the Flow
Plugs.
Lock the Tubing Clamp and the water will be retained in the line.
Take the primed Christmas Tree I-V™ and the bottle to the Christmas
tree and you are ready to hook up the tree on the Christmas Tree I-V.
Put the bottle on a small table or box so that the bottom of the bottle is
higher than the hole where the Flow Plugs are to be inserted.
Put the first Flow Plug tip into the hole so that the black rubber is com-
pletely in the hole and turn the wing nut clockwise 2-3 times to expand
the black rubber bushing. Put the other Flow Plug partially in the re-
maining hole and unlock the tubing clamp and wait for water to trickle
out around that Flow Plug. After water appears push the Flow Plug
completely into the hole and turn the wing nut clockwise 2-3 times to
expand the black rubber bushing. DO NOT OVERTIGHTEN or the
Flow Plug will back out of the hole.
Give a gentle tug to the Flow Plugs and they should not come out of the
holes. The rubber will form an airtight and leak proof seal around the
holes and the Flow Plugs.
To refill the bottle simply lock the tubing clamp and fill bottle, replace the
cap and then unlock clamp. The bottles can be gift wrapped or deco-
rated. Check the water level at least daily and DO NOT ALLOW the
level to go below the tubing end as the holes will sap over after a couple
of hours. Once hooked up you can transfer the Christmas Tree I-V to a
larger container if desired.
Safe Christmas Products 2318 Masters Missouri City, TX 77459
www.safechristmas.com
Packing List: 5 feet of tubing, two short tubes, 3-way Barbed Connector, Snap-On
Lid,
Tubing Clamp, two Flow Plugs, 1/2” Drill Bit
You will need to supply an electric drill and a gallon bottle (typically water or milk)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern